SIRAX BT7300/BT7350 AC/DC 电流互感器 300AAC/400VDC
SIRAX BT7300/BT7350电流互感器全进口质量好 !SIRAX BT73x0具有电能表功能的 AC/DC 电流互感器: 输入范围电流 300 AAC / 400 VDC输入范围。SIRAX BT7300/BT7350电流互感器具有集成电能表功能,用于监控单相交流和直流应用。大量的测量变量、在很大 1000 VDC 或 800 VAC 下高达 300 AAC 或 400 ADC 的很大电流允许设备的多种用途。 SIRAX BT73x0电流互感器只能由具备相应电气上岗证的工程师安装并操作,持电气证书是合格人员经过培训和经验,能够识别产品处理过程中的风险和危害......
产品描述
SIRAX BT7300/BT7350电流互感器全进口质量好!SIRAX BT73x0具有电能表功能的 AC/DC 电流互感器: 输入范围电流 300 AAC / 400 VDC输入范围。SIRAX BT7300/BT7350电流互感器具有集成电能表功能,用于监控单相交流和直流应用。大量的测量变量、在很大 1000 VDC 或 800 VAC 下高达 300 AAC 或 400 ADC 的很大电流允许设备的多种用途。
SIRAX BT73x0电流互感器只能由具备相应电气上岗证的工程师安装并操作,持电气证书是合格人员经过培训和经验,能够识别产品处理过程中的风险和危害。能够理解并遵守其中包含的安全和警告。确保组装、安装和维护期间的安全工作环境。断开一次导线的电源,并将其固定,防止意外重新切换。高强度磁场可以改变变压器测量的值。避免安装在永久磁铁、电磁铁或铁块附近,以免引起磁场的强烈变化。如果存在不规则情况,建议在很合适的区域重新调整或移动变压器。
- 由 PBT 制成的抗断裂塑料外壳
- 符合 UL94 V0 的阻燃和自熄性
- 双向能量测量
- 很大限度。电流范围高达 300 AAC / 400 ADC
- 很大限度。电压范围高达 800 VAC / 1000 VDC
- 与测量电路的电流隔离
- 通过配置App进行配置
- 串行 RS485 Modbus/RTU 输出
- DIN 导轨或墙壁安装,用于垂直或水平位置
SIRAX BT7200 | SIRAX BT7250 | SIRAX BT7300 | SIRAX BT7350 | |
System type | 1-phase AC/DC | |||
Type of measure | TRMS (monopolar) or DC | |||
Current measurement | Integrated Hall effect current sensor | |||
Installation form | DIN rail mounting | |||
Mounting position | arbitrarily, vertically or horizontally | |||
Input | ||||
Input range current | 50 A AC/DC | 300 AAC / 400 VDC | ||
Input range voltage | 800 VAC / 1000 VDC | 80 VAC / 100 VDC | 800 VAC / 1000 VDC | 80 VAC / 100 VDC |
Transformer ratio | 1,0 standard (customizable) | |||
Power supply | 9...30 VDC | |||
Absorption | < 1.3 W | |||
Max. cable diameter | 14 mm | 32 mm | ||
Output | ||||
Output range | RS485 Modbus/RTU | |||
Sampling rate | 11 kHz | |||
Working frequency | DC or 1...400 Hz | |||
Accuracy | ||||
Accuracy |
Voltage, Current, Active power, Phase to phase voltage: < 0.5% F.S. / Frequency: ± 0.1 Hz / Energy: ± 1% / Reactive power: <1.5% F.S. / Apparent power from 0.1 In to In: ± 1% rdg / Apparent power from 0.05 In to 0.1 In: ± 2% rdg |
SIRAX BT7200 | SIRAX BT7250 | SIRAX BT7300 | SIRAX BT7350 | |
Resolution | 12 bit | |||
Temperature coefficient | < 200 ppm/°C | |||
Crest factor | 1.8 | 1.4 | ||
Input impedence | 1 MΩ ±1% | |||
Safety and environmental conditions | ||||
Operating temperature | -15 ... +65 °C | |||
Humidity | 10 ... 90 % (not condensing) | |||
Housing protection IP | IP20 | |||
Isolation | 3 kV on bare wire for Current measurement / 4 kV for Voltage measurement | |||
Overvoltage category | CATIII up to 600 V CATII up to 1000 V | CATIV up to 100 V | CATIII up to 600 V CATII up to 1000 V | CATIV up to 100 V |
Altitude | max. 2000 m | |||
Mechanical properties | ||||
Housing material | PBT | |||
Filling | Epoxy Resins | |||
Flammability | UL94 V-0, self-extinguishing, non-dripping, halogen-free | |||
Weight | 80 g | 370 g | ||
Connections | Plug-in terminals 3.5 mm, 1x4 Pol, 2x2 Pol | |||
DIP switch | 2 Pol | |||
Programming | Via DIP switch, Modbus RTU and software | |||
Mounting | Screw grooves for vertical and horizontal panel mounting / Fasteners for mounting on DIN rail | |||
Dimensions | 46.1 x 63 x 26.4 mm (without terminals) | 89.1 x 99.25 x 28.5 mm (without terminals) | ||
Standards | ||||
Adhered standards | EN61000-6-4; EN64000-6-2; EN61010-1 | |||
Order data | ||||
Article-No. | 179970 | 179988 | 179996 | 180000 |
sirax-bt7300-back
SIRAX BT7200 | SIRAX BT7250 | SIRAX BT7300 | SIRAX BT7350 | |
System type | 1-phase AC/DC | |||
Type of measure | TRMS (monopolar) or DC | |||
Current measurement | Integrated Hall effect current sensor | |||
Installation form | DIN rail mounting | |||
Mounting position | arbitrarily, vertically or horizontally | |||
Input | ||||
Input range current | 50 A AC/DC | 300 AAC / 400 VDC | ||
Input range voltage | 800 VAC / 1000 VDC | 80 VAC / 100 VDC | 800 VAC / 1000 VDC | 80 VAC / 100 VDC |
Transformer ratio | 1,0 standard (customizable) | |||
Power supply | 9...30 VDC | |||
Absorption | < 1.3 W | |||
Max. cable diameter | 14 mm | 32 mm | ||
Output | ||||
Output range | RS485 Modbus/RTU | |||
Sampling rate | 11 kHz | |||
Working frequency | DC or 1...400 Hz | |||
Accuracy | ||||
Accuracy |
Voltage, Current, Active power, Phase to phase voltage: < 0.5% F.S. / Frequency: ± 0.1 Hz / Energy: ± 1% / Reactive power: <1.5% F.S. / Apparent power from 0.1 In to In: ± 1% rdg / Apparent power from 0.05 In to 0.1 In: ± 2% rdg |
sirax-bt7350-front
SIRAX BT7200 | SIRAX BT7250 | SIRAX BT7300 | SIRAX BT7350 | |
Resolution | 12 bit | |||
Temperature coefficient | < 200 ppm/°C | |||
Crest factor | 1.8 | 1.4 | ||
Input impedence | 1 MΩ ±1% | |||
Safety and environmental conditions | ||||
Operating temperature | -15 ... +65 °C | |||
Humidity | 10 ... 90 % (not condensing) | |||
Housing protection IP | IP20 | |||
Isolation | 3 kV on bare wire for Current measurement / 4 kV for Voltage measurement | |||
Overvoltage category | CATIII up to 600 V CATII up to 1000 V | CATIV up to 100 V | CATIII up to 600 V CATII up to 1000 V | CATIV up to 100 V |
Altitude | max. 2000 m | |||
Mechanical properties | ||||
Housing material | PBT | |||
Filling | Epoxy Resins | |||
Flammability | UL94 V-0, self-extinguishing, non-dripping, halogen-free | |||
Weight | 80 g | 370 g | ||
Connections | Plug-in terminals 3.5 mm, 1x4 Pol, 2x2 Pol | |||
DIP switch | 2 Pol | |||
Programming | Via DIP switch, Modbus RTU and software | |||
Mounting | Screw grooves for vertical and horizontal panel mounting / Fasteners for mounting on DIN rail | |||
Dimensions | 46.1 x 63 x 26.4 mm (without terminals) | 89.1 x 99.25 x 28.5 mm (without terminals) | ||
Standards | ||||
Adhered standards | EN61000-6-4; EN64000-6-2; EN61010-1 | |||
Order data | ||||
Article-No. | 179970 | 179988 | 179996 | 180000 |